Push pop-up , magnetic StorageClassic award-winning designThe Mi Precision Screwdriver has won five international
design awards; namely the iF, Red Dot, Japan Good
Design, IDEA and Chicago Good Design awards. The
Xiaomi Electric Precision Screwdriver uses the same popup
design, featuring a convenient, push-to-release
mechanism.* The image on the left shows the Xiaomi Electric Precision Screwdriver, and the image on the right shows the Mi Precision Screwdriver. This image is used only to illustrate the different dimensions of the two products.
Electric precision screwdriverEnhanced precision efficiencyThanks to the powerful magnetic motor with a speed of up to 170rpm*. and the all-metal gearbox, the screwdriver has a screwdriving bit concentricity of no more than 0.2mm* when rotating, for greater precision efficiency.
170rpm
Powerful magnetic motor speedAll-metal
gearbox≤0.008inch
screwdriving bit concentricityCompact design with an extra-long battery life400+ precision screws on one full chargeThe screwdriver has a shaft diameter of just 0.65 in.* (16.4 mm). The built-in rechargeable lithium battery is powerful and long-lasting and can process 400+ precision screws on one full charge*.
0.65
inch
shaft diameter400+
Pieces
precision screws24 x S2 steel precision screwdriving bits in 9 major typesThe 24 x high-quality S2 tool steel screwdriving bits are durable and tough and have a hardness of up to 60HRC*.The 24 types of precision screwdriving bit are ideal for dismantling and assembling most standard electronics and new small household appliances.
18PiecesTwo-speed precise torque adjustment
Precision screw protection
Overcurrent charging protection*0.008 inch fine bristles: Diameter data from the Shenzhen Silver Star Intelligent Technology Co., Ltd. lab. 10 individual bristles were measured using a micrometer with a precision of 0.0004 inch. Results indicate a bristle diameter of 0.008 inch, with a variation of 土0.002 inch.* Spindle runout (i.e. precision bit concentricity) test method: A standard test rod is inserted into the output shaft. A laser diameter gauge is used to measure the runout at a distance of 1 inch from the end surface of the output shaft.* The dimensions stated may vary or be inaccurate due to different measurement conditions.* Screwing test method: The device is fully charged until the white lamp is illuminated. The ST2 x 0.2 inch self-tapping screw is then driven into the pine board until the battery runs out.* Hardness varies by ±2HRC. Screwdriving bit hardness tests were conducted by the National Light Industry Tool Hardware Quality Supervision & Testing Station, Shanghai. Report No.: G20200215.* Torque at level I varies by ±0.03Nm and torque at level II varies by ±0.08Nm. Torque test method: The fully charged device is run without load for 2 minutes and a torque tester is then used to measure the torque at levels I and II.* The battery was tested by the Southern Testing Company of the China Certification & Inspection Group. Report No.: SET2019-08673. The battery protection tests were conducted by Precise Testing & Certification (Guangdong) Co., Ltd.; Report No.: PTC20032303001S-GB01.* Unless otherwise indicated, all data referred to on this page is from the HOTO Laboratory. Data may vary or be inaccurate due to differences in the objective environment and other factors.